Vibration Reducing Handles Main Parts; Assembly Instructions; Periodic Maintenance - Chicago Pneumatic CP 1230 Sicherheits- Und Betriebsanleitung

Safety and operating instructions
Vibration reducing handles
main parts
Bearing
A.
B. Spring
C. Handle sleeve
Handle
D.

Assembly instructions

Reasonable care must be taken during assembly and
disassembly of the tool to avoid burring, scoring or
distortion of closely fitting precision built parts.
1. Check all metal to metal surfaces for nicks and
burrs before and during assembly.
2. Before re-assembly, lubricate all O-rings and coat
all moving parts of tool with recommended
lubricants.
3. During assembly take care to keep dirt out of
tool, particularly between mating surfaces.
4. The front head bolts should be tightened so that
the springs or bushings are evenly compressed.
5. When assembly is complete pour about ½ oz.
(1.5cl) of the recommended oil into the air inlet
and operate the pneumatic breaker at reduced
throttle for 10–15 seconds. When operating the
pneumatic breaker on the floor, do so at reduced
throttle to avoid damage to piston, anvil block
and front head.
18
www.CrowderSupply.com • Toll Free: 888-883-5144
CP 1210, CP 1230, CP 1240
6. Install the spring pins with the slots in opposite
directions and at a 45 degrees angle. See
illustration shown below (Only valid for CP
1210).
7. Before assembling the back head onto the
cylinder, check that the seal protrudes
approximately (B) 1 ⁄
16
of the cylinder.

Periodic maintenance

After each operating period of approximately 150
impact hours or twice a year the machine must be
dismantled and all parts be cleaned and checked.
This work must be performed by authorized staff,
trained for this task.
9800 0608 90d | Original instructions
" (1.6 mm) from the face