Wep Encryption - Hama 00062764 V2 Bedienungsanleitung

Now switch to the Advanced tab.
Wireless mode allows you to set the standard to be used. This depends on the other devices used in your
network. You can choose either 802.11 B only mode (11 Mbps): Then this standard only is used; or 802.11 B/G
mixed mode up to 54 Mbps): Both standards are then supported; If you are not sure which of the standards
your devices support, you should use the mixed mode (802.11 B/G mixed mode). Make all other settings as
shown in the image below.
Click Apply to confirm your entries.
This device can be used with the following encryption
types:
64 and 128 bit WEP encryption
WPA Encryption
Note!!! Encryption is deactivated by default.
However, for security reasons, we recommend
that you always use encryption.

7.2.2.1 WEP encryption

Wired Equivalent Privacy (WEP) is a standard encryption algorithm for WLAN. It both controls the access to
the network and guarantees the integrity of the data. This method is considered vulnerable due to a range of
weaknesses.
If you want to use WEP encryption, select the following
settings:
Two options are available for the Authentication type
under WEP.
Select Open if all clients are to be enabled for WLAN.
Now there is virtually no other authentication.
Select Shared if you want to use authentication with the
challenge response process. A shared code is used for
authentication in this method. All WLAN users must know this code.
All other selection options under Authentication type are meaningless under WEP.
15