Configuring The Operating System And Computer (Windows®) - Hama 00062764 V2 Bedienungsanleitung

To use WPA2 encryption, select WPA2-PSK under
Authentication type and AES under Encryption.
Now enter the code used in the WPA preshared key field.
The code entered must be absolutely identical with that
used in the network. It must be min. 8 and max. 63 random
characters for ASCII.Letters (A-Z), numbers and
punctuation marks can be used. 64 characters are
required for HEX, whereby only characters from 0-9 and
a-f can be used. If you do not have this code, it can be
found in your router/access point or you can ask the
person responsible for these devices.
Save the settings and click OK.
To activate the profile created, switch to the Profiles tab, select the profile and then click Activate.
3. Configuring the operating system and computer (Windows®)
After you have successfully installed the network adapter, you still have to install or configure a protocol. This
protocol governs the data exchange between the computer and the network. TCP/IP is most common. Each
computer has to be assigned its own address for the protocol. Automatic address assignment is only reliable
if a DHCP server exists in the network, e.g. a router or access point. If you have one of these devices with a
DHCP function, you should leave the setting on "Get automatically".
Proceed as follows to check the settings on your PC:
Start -> Settings -> Control panel -> Network connections
Select the connection (network adapter) via which your
PC is connected to the router, e.g. "LAN connection".
When you right-click the corresponding connection, the
following screen is displayed when you select Properties.
Select the Internet Protocol (TCP/IP) entry in the list and
click Properties.
9