Uninstalling The Driver And Configuration Program On Windows; Installing The Driver And Configuration Program On Mac Os - Hama 00062764 V2 Bedienungsanleitung

Select Optain an IP address automatically and Optain
DNS server address automatically, if there is a DHCP
server in your network. Confirm by clicking OK, and
again in the subsequent window.
Your PC is now configured such that the router assigns the
IP address automatically.
If you do not have a device with an integrated DHCP
server, you must assign the IP addresses manually. The
following example describes basic setup using manual
address assignment. For local networks, special address
ranges are provided which are not transmitted over the
internet. As an example, a range that you can use for your
network is 192.168.1.1 to 192.168.1.254. The first PC is
assigned the address 192.168.1.1, the second 192.168.1.2,
the third 192.168.1.3, etc.
Select Use the following IP address and enter your IP address
in accordance with the sample.
1.PC = IP address 192.168.1.1 Subnet mask 255.255.255.0
2.PC = IP address 192.168.1.2 Subnet mask 255.255.255.0
Click Ok to confirm your entries.
4. Uninstalling the driver and configuration program on Windows®
Select Start => Settings => Control Panel => Software
To do so, select Hama Wireless Utility and click Remove. At the next prompt, click Remove completely.
Remove the device from your computer when prompted to do so. Afterwards click OK.
The program is now deleted from your computer.
After the software is removed, you may have to restart the system. Save all open documents and close all
programs before restarting the PC.
5. Installing the driver and configuration program on MAC OS X
Before installation, please save any open documents you may be working on. Then close all running
programs. Ensure that you have administrator authorisations to enable you to install the driver
correctly.
Connect the Hama WLAN USB stick to a free USB 2.0 port. Then start your Apple computer.
10