Conceptronic CHD3SATA Schnellstartanleitung Seite 4

ENGLISH
1.2 Jumper setting hard disk
The jumper setting from the hard disk should be set to 'MASTER' or 'SINGLE' position.
How make the right setting depends on the type and brand of hard disk.
Please contact the dealer from the hard disk or check the settings on your hard disk, if you
encountered problems with it.
2. Software Installation CHD3FWU / CH3SATA
2.1 Windows Me/2000/XP – CHD3FWU /CHD3SATA
No driver is required. These Windows operating systems already contain a driver that
supports the CHDFWU and CHD3SATA Harddiskbox. Just slide the Harddiskbox into the
USB /Firewire (CHD3FWU) or SATA (CHD3SATA) port of the PC or notebook. A new drive
icon will appear in 'My Computer', when there is a valid partition on the hard disk. If not,
please check the 'Help' of your operating system.
2.2 Windows 98(SE) – CHD3FWU
If you are using Windows 98(SE), please find the description of the driver installation further in
this manual.
3. Safely removing the Harddiskbox CHD3FWU
The device must be deactivated before disconnecting the device otherwise data could be lost.
You can deactivate "USB Mass Storage Device" by double clicking the icon in the taskbar.
Windows 98(SE) Windows ME / 2000 / XP
"Remove or eject hardware components" appears on the screen after double clicking. Activate
the appropriate USB component here and confirm with "Deactivate". A warning appears if you
do not deactivate the device before disconnecting.
4