B Conditioner Adjustments; Position Of Top Hood; Moving The Conditioning Rotor - LELY SPLENDIMO 320 MC Betriebsanleitung

B CONDITIONER ADJUSTMENTS

The conditioner of the SPLENDIMO MC mower conditioner
allows adjustment possibilities for the position of the top
hood and conditioner rotor. In addition, a different rotor
speed can be obtained.
Should the conditioner tend to get jammed in a long crop, it is
recommended to adjust the conditioner (i.e. increase the
space around the conditioner). The reverse situation applies
if the machine fails to take up a short crop effectively making
it impossible to build a neat swath (i.e. reduce the space
around the conditioner).

Position of top hood

B.1
The clearance between the top hood and the conditioner's
rotor can be adjusted in three positions.
- Unlock the latch of the crop inlet plate.
- Dismount the 10 bolts on either side of the machine (A,
fig. B-1).
- Position the plate in front of the bolt holes and fit the bolts.
- Tighten the bolts firmly.

Moving the conditioning rotor

B.2
The clearance between the conditioner rotor and the cutter
bar can be adjusted in four positions.
- Open the V belt housing.
- Remove the tension from the V-belts.
- Dismount the 2 bolts on either side of the machine (B,
fig. B-1).
- Position the entire conditioner component in front of the
correct bolt holes and fit the bolts.
- Tighten the bolts firmly.
- Tighten the V-belts. Adjust belt tension in such a way that,
if a 70 N (7 kg) force is exerted on the middle, the V-belt is
pushed in 10 mm (fig. B-2).
- Close the V belt housing.
Supplement B
A, 5x, 5x
B
10 mm
70 N (7 kg)
53
B-1
B-2