Onderhoud; Maintenance After Operations; Lubrication - LELY SPLENDIMO 320 MC Betriebsanleitung

7 ONDERHOUD

• Correct machine servicing is necessary with a view to
reliable and safe working.
• Install supports underneath the cutter bar if it is lifted
from the ground, and you intend to carry out work to
the machine.

Maintenance after operations

7.1
- Clean the machine thoroughly. After jet-cleaning allow for
a few moments rotation of the discs so that the water is
swept away.
- Check the mower knives and discs for tightness and
damage (torque: see § 7.3).
- Check the safety covers for damage.
- Grease the machine with a rust preventive.
- Grease the piston rods with an anti-corrosion agent if a
longer period of inactivity is anticipated.
Remove the agent when putting the machine back into
operation. If not, sealing of the ram may be affected after
hardening of the anti-corrosion agent.

Lubrication

7.2
- PTO shaft to be greased every 8 working hours by the
grease nipples on the cross assemblies, protection tubes
and free wheel clutch (fig. 15).
- Profiled tubes of the PTO shaft to be greased every 8
working hours (fig. 15).
- Grease the bearing blocks (fig. 16) of the conditioner rotor
every 8 working hours.
- Grease the pivoting points of the ram and support arm
every 40 working hours (fig. 17).
- Apply a few drops of oil to the cams of the breakback
device every 40 working hours (fig. 18).
- Grease or lubricate all remaining pivot points every 40
working hours.
8 h
8 h
8 h
8 h
8h
45
15
16