Preparing The Equipment For Use; Assembly - Blower Operation - Solo 440 Gebrauchsanweisung

Preparing the equipment for use

6. Preparing the equipment for use
Observe all safety instructions during assembly and
dismantling work!

6.1 Assembly - blower operation

The total pipe for the blower operation consists of three
parts:
Blower pipe (16) to be fitted to the standard machine.
Round air nozzle (17) to be fitted to the blower pipe.
Flat nozzle attachment (18) (optional use) to be fitted
to the round air nozzle.
These parts are fitted in the same manner. When
pushed together, the respective arrows must be
perfectly aligned, then secure the part by turning it 45°.
For dismantling, initially turn the part again, until the
arrows are aligned, then pull the components apart.
Blower pipe assembly (16)
Fig. 3
a) Push blower pipe (16) with groove (22) over cam
(23) of the standard machine.
The arrows on the blower pipe and the standard
machine must be aligned accurately, when the parts
are pushed together (the wide groove (22) over the
large cam (23), and the narrow groove over the
smaller cam).
b) Turn the blower pipe 45º, so that arrow on the
blower pipe is turned down, until the blower pipe
audibly clicks into place.
c) Flick lock (6) forward.
Blower pipe dismantling
! Flick lock (6) back up.
! Turn the blower pipe back, so that the arrows on the
blower pipe and on the standard equipment are
again aligned accurately.
! Pull the blower pipe from the standard equipment.
ENGLISH 10
Round air nozzle assembly (17)
a) The round air nozzle (17) has two longitudinal
adjustments.
Push the nozzle either into pos. L (long) or in pos. K
(short) up to cam (25) on blower pipe (16) (when the
nozzle is pushed onto the blower pipe, on the round
air nozzle and on the blower pipe must be aligned
accurately).
b) Turn the round air nozzle 45º, so that arrow on the
round air nozzle is turned down, until it audibly clicks
into place.
To modify the overall length of the pipe, initially turn
the round air nozzle back, so that the arrows are again
aligned accurately. Then move the round air nozzle into
alternative longitudinal position, and secure by turning
it.
To disassemble the round air nozzle, initially turn it
back, so that the arrows are aligned again accurately.
Then pull the round air nozzle from the blower pipe.
Flat nozzle attachment (18)
Fig. 5
a) Push the flat nozzle attachment onto the round air
nozzle in accordance with the arrows on the flat
nozzle attachment and on the round air nozzle.
b) Turn the flat nozzle attachment 45°, so that edge
protector clip (18a) is turned down into its operating
position. Edge protector clip (18a) protects the
plastic pipe, when it contacts the ground during
operation.
To dismantle the flat nozzle attachment from the round
air nozzle, turn it back and pull it off, after aligning the
arrows.
Fig. 4