When Performing Any Assembly, Maintenance, Repair And Cleaning Work; Fuelling; When Transporting The Equipment; Preparing The Equipment For Starting - Solo 440 Gebrauchsanweisung

1.3 When performing any assembly, maintenance, repair and cleaning work

!
Never assemble, maintain, repair or store the power tool near open flames.
!
When performing any assembly, maintenance, repair or cleaning work – even initial equipment assembly – observe
the following:
- Set the ON/OFF switch to "0" (exceptions are the adjustment of the carburettor and the idle position),
- Pull the spark plug cap before opening the fan cover, for example when fitting the vacuum pipe or for cleaning.
- Prevent fuel spillages. Close the fuel tank by hand and test the entire tank for leaks. It is advisable to drain the
tank before carrying out any work.
!
Regularly service this machine. Only carry out those maintenance jobs and repairs, which are described in this
manual. A specialised service centre will carry our all other jobs.
!
For any repairs only use original parts from the manufacturer.
!
Do not modify, alter or change the machine as this may impact on the safe operation of the machine and may lead
to accidents and injuries!

1.4 Fuelling

Petrol is very light and highly flammable. Keep away from open flames and never spill fuel. Do not smoke at
the operating site or at and near the refuelling site!
!
Stop the engine prior to refuelling.
!
Let the engine cool down before refuelling - fire risk!
!
Open the tank lid slowly to allow any excess pressure in the tank to be reduced without the risk of petrol spraying
out.
!
Fuel may contain substances similar to solvents. Prevent products made from mineral oil coming into contact with
skin and eyes. Wear protective gloves during filling with fuel. Frequently change and clean protective clothing.
!
Avoid breathing in fuel vapour.
!
The refuelling site should be well ventilated.
!
Avoid any soil spillage of fuel or oil (protection of the environment). Use a suitable mat.
!
Immediately clean any spilled fuel on the machine. Change contaminated clothing without delay.
!
Firmly tighten all tank lids. This will reduce the risk of spillage from lids, which have become loose from engine
vibrations.
!
Check for petrol leaks. Do not start the machine or work with the machine if there is a petrol leak. Life threatening
risk from burns!
!
Store fuel and oil in approved and correctly labelled containers.

1.5 When transporting the equipment

!
Always turn off the engine when transporting the machine.
!
To prevent fuel running out and associated damages, secure the equipment against tipping over during vehicle
transportation. Check the tank for leaks. It is advisable to drain the tank before transportation.
!
Drain the tank before despatching the equipment.

1.6 Preparing the equipment for starting

Check the complete machine for operational safety.
!
The stop switch should function properly.
!
The throttle must have freedom of movement and return to the idle position on its own accord.
!
The impeller and the blower casing must be in a problem-free condition. Damage to the blower casing can lead to
an injury hazard through escaping foreign objects. In this case do not use the device, have it checked by a dealer
!
Ensure the spark plug cap and the ignition cable are connected firmly. A loose connection may cause a spark, which
can ignite any existing fuel:air mixture - fire hazard!
Should the check reveal any irregularities or recognisable damage (also to the frame), incorrect adjustments or reduced
efficiency of the machine, do not commence work. Take the power tool to a specialised workshop and have it checked.
Safety regulations
ENGLISH 5