Date/Time Stamp; Video Quality; Loop Recording; Audio Recording - Lamax Electronics DRIVE C4 Benutzerhandbuch

2) Date/Time Stamp

Adds a date and time stamp to the recording. This can either be date only,
date and time or off completely.

3) Video Quality

With the "Video Quality" function you can adjust the compression rate
of the recorded video data and thus its size. When video quality is set to
high, videos have minimal compression and the recordings are of the hi-
ghest quality. When video quality is set to low, the compression reduces
the amount of data it uses so as to fit as much as possible on the memory
card with the smallest loss in video quality.

4) Loop Recording

Camera recordings are subdivided into individual sequences, whose len-
gth can be manually adjusted or turned off completely. The sequences
can be set to 1, 3 or 5 minutes. The sequence length is indicated by the
icon on the left side of the display.

5) Audio Recording

Lets you mute the audio to prevent unwanted audio being recorded. Au-
dio recording can also be turned on and off using a quick function.

6) Exposure

Lets you adjust the exposure as needed. Video recording exposure can be
adjusted from -2 - +2 in steps of 1/3.

7) Motion Detection

When motion detection is activated it automatically starts recording the
moment movement is detected in the visual field of the lens. The camera
stops recording after motion ceases.
LAMAX DRIVE C4 Car Camera Settings – Photo Mode

1) Image Resolution

Image resolution can be set in the photo settings menu. The photo
settings menu is accessed by pressing "MENU" in photo mode. Use the
"UP" and "DOWN" arrows to scroll to "RESOLUTION" and choose one of
the options – 12 MP, 10 MP, 8 MP, 5 MP, 3 MP, 2 MP, 1.3 MP and VGA.
2) Date/Time Stamp
Adds a date and time stamp to the photo. This can either be date only,
date and time or off completely.
7