Extension Cables - Solter TAPP-1300 Bedienungsanleitung

EXTENSION CABLES

Where an extension cable has to be used to connect the machine, proceed in accordance with the fol-
lowing
AMP.
80-100 A
130-150-140-160 A
160-180 A
180-200 A
Where the earth cable or the clamp cable for welding is to be extended:
PROTECTION DEVICES
THERMAL PROTECTION
During prolonged use at maximum power, the equipment will stop on reaching maximum temperature
values and the amber pilot light will come on. The fan will continue to function in order to cool the ma-
chine, and in a few minutes the equipment will start again.
INADEQUATE ELECTRICAL POWER
The machine will stop automatically if the electrical power (V) is inadequate.
The amber LED nº 3 will light up.
Always check that the electrical supply is within the established limits.
Special Characteristics of the STYL PRO model:
The amber LED will flash if the power supply has been cut off momentarily. This may be due to an ex-
cess or deficit of power.
WELDING PROCEDURE USING COATED ELECTRODES
• Electric arc welding using coated electrodes is a procedure through which a joint is made between
two metallic parts, making use of the heat generated by an electric arc which is produced between the
melting electrode and the material to be soldered.
• Welding equipment may be DC or AC; the former can weld any type of electrode while the latter can
only weld electrodes made for AC.
• The manufacturing characteristics of these machines guarantee a high degree of arc stability with re-
spect to length variations from the electrode caused by the welder's hand.
• The electrode is made up of two basic parts:
a) The core which is the same type of base material (aluminium, iron, copper, steel, stainless
steel) and provides material to make the join.
b) The coating, which is made of various mineral and organic substances mixed together and
with the functions of:
Gas protection. One part of the coating is activated at arc temperature and moves air away
from the area, creating a column of ionised gas which protects the melted material.
Provision of agglutinating and dross materials: A part of the coating melts and provides ele-
ments which combine with the core material in the fusion process.
The main types of coating are:
Stick welding coatings. These coatings lend the seam a better appearance and they are
widely used. Welding may be carried out using both AC and DC currents with both polarities.
Basic coatings. These are used essentially for high quality mechanical welding, although the
SOLTER
SOLDADURA S.L.
10m
2,5 mm2
2,5 mm2
2,5 mm2
4 mm2
Up to 5 m
Up 5 to 20 m
Up 20 to 30 m
INVERTER
Extensions of
25m
2,5 mm2
4 mm2
4 mm2
6 mm2
Cable section of 16 mm2
Cable section of 25 mm2
Cable section of 35 mm2
THIS DATA IS APPROXIMATE
50m
4 mm2
4 mm2
6 mm2
6 mm2
3