Operation; A) Locking - KeyMatic KM 300 IQ+ Bedienungsanleitung

12. Operation

a) Locking

There are two possible ways of locking:
• Press the button "Lock" on the remote control (lower button). "M" is faded in to
• Press the button "Lock" (left upper button) on the radio remote control for about
The locking bolt is launched into the previously determined locking position, the
symbol „Locked" ( ) appears. A longer audio signal sounds on the door lock
actuator after completing this procedure.
If the lock has in the meantime been turned by a hand wheel on the inside or by
a key on the outside, then the actuator does not move to the programmed position
"Locked" for safety reasons, but it is turned towards „Locked" till it reaches the
stop.

Please Note:
A jamming lock is, if the need may be, (after previous manual operations on the hand
wheel or with the key ) recognised as „Locked" to the end stop. In this case the symbol
„Locked" ( ) could be shown and the acoustic acknowledgement signal sounded out,
although the lock is not completely locked.
You may be able to overcome the jamming of the lock by repeated locking attempts if this
is just a disturbance occurring in normal operations (i.e. due to temperature influences).
the display.
one second. The radio tower symbol appears in the display briefly and the
memory slot number of the radio remote control used is faded in.
Unintended locking and unlocking procedures are avoided where
possible by pressing the key on the radio remote control for a longer
time (i.e. by briefly pressing a key when transporting the remote in a
bag etc.) This is of course the case for all 3 keys on the remote control.
65