Before the adjustments on the door lock actuator are continued, this has to be mounted above the
fastening element on the cylinder lock.
• Insert the key into the cylinder lock, unlock the
lock and put the key into the neutral position (in
which the key could be withdrawn).
• Guide the door lock actuator over the key. Posi-
tion it completely on the fastening element.
• The door lock actuator should be mounted on
the fastening element with the two hexagon
screws extended at first (M3 * 14mm).
Screw in the screws fully with the enclosed
hexagon wrench without applying any force.
• Open the door. This is necessary so that the
door lock actuator can detect the end stops of
the lock in the following initialisation drive without
any hindrance.
54