Changing The Double Hotkey - G&D DP1.2-MUX4-USB Installation Und Bedienung

Configuration

Changing the double hotkey

If the use of double hotkeys is enabled (see page 18), press the double hotkey and the
Backspace key simultaneously to start the setup mode of the KVM switch. Switching
of channels takes place by pressing the double hotkey and a select key at the same
time.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current double hotkey:
1. Requirement: enabling of the double hotkeys (see page 18).
2. Press Double hotkey+Backspace
ously to enable the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
Ctrl  enables Ctrl+Shift double hotkey
Alt  enables Alt+Shift double hotkey
Alt Gr  enables Alt Gr+Ctrl double hotkey
Win  enables Win+Ctrl double hotkey
Shift  enables Shift+Win double hotkey
1. Requirement: enabling of the double hotkeys (see page 18).
2. Use the terminal emulator to establish a connection to the KVM switch.
3. Use the
Arrow
4. Press the
Space
Ctrl+Shift
Alt+Shift
Alt Gr+Ctrl
Win+Ctrl
Shift+Win
5. Press the S
20 · G&D DP1.2-MUX4-USB
or keys to select the
Arrow
key (repeatedly) to enable the desired double hotkey:
 enables Ctrl+Shift double hotkey
 enables Alt+Shift double hotkey
 enables Alt Gr+Ctrl double hotkey
 enables Win+Ctrl double hotkey
 enables Shift+Win double hotkey
key to save your settings.
(default: Ctrl+Shift+Backspace
Hotkey
) simultane-
entry.