Permanent Switching Of Usb 2.0 Devices; Enabling Permanent Switching Of Usb 2.0 Devices - G&D DP1.2-MUX4-USB Installation Und Bedienung

Switching between computers
Messages
The KVM switch confirms the successful execution of a command and otherwise
sends a meassage.
Message
In All
[x]
E01
E06
E10
E13

Permanent switching of USB 2.0 devices

In the default settings of the KVM switch, KVM data and the data of devices con-
nected to the »USB 2.0 Devices« interface are forwarded to the computer of the
active channel.
Enable USB pinning (see page 34) if you want to permanently switch the data of
devices connected to the »USB 2.0 Devices« interface to a defined channel. The per-
manent switching of these devices remains the same even when switching the KVM
channel.

Enabling permanent switching of USB 2.0 devices

How to permanently switch USB 2.0 devices to a channel:
1. To activate the setup mode, press
Hotkey+Backspace
If the hotkey delay is enabled, press and hold the key combination for
seven seconds.
2. Press and hold the
3. Additionally, press one of the following keys:
1  Permanent switching of USB 2.0 devices to channel 1
2  Permanent switching of USB 2.0 devices to channel 2
3  Permanent switching of USB 2.0 devices to channel 3
4  Permanent switching of USB 2.0 devices to channel 4
12 · G&D DP1.2-MUX4-USB
Meaning
switching to channel
invalid channel number (out of range)
channel switching failed
invalid command
invalid value (out of range)
(default: Ctrl+Backspace
U key.
successful
[x]
) at the same time.