Berker MT 701 CT Bedienungsanleitung Seite 33

MT 701 CT
Downloading the user software
Recommendation: Due to large data volumes it is recommended to program the user
software via the integrated USB interface (14).
The connection to the PC requires a USB line with plug type B.
The user software and the USB driver has to be installed before the device is con-
nected to the PC.
The drivers are initialized when the device is connected for the first time to the PC.
The corresponding access rights are required.
Some PC operating systems perform a check during the initialization (when the de-
vice is connected for the first time to the PC) whether the USB drivers are certified.
The corresponding messages can be ignored and the installation continued.
Connect only one device to the PC.
 After installation of the device: Remove design frame (16) from the device.
The USB interface can be accessed (14) at the left edge of the device – in case of
a vertical installation at the lower edge.
 Establish a connection with the programming PC via the USB line.
 Program the user software.
 After programming, disconnect the USB terminal and attach and press on the design
frame (16).
GB
33