Berker MT 701 CT Bedienungsanleitung Seite 29

MT 701 CT
Viewing the service address
 Open the Service page.
 Open System settings.
 Select Service address.
The pre-set maintenance will be displayed.
Changing the colour settings
The colour setting is visible only if programmed.
 Open the Service page.
 Open System settings.
 Select Colour settings. Select desired colour scheme. Accept the entry by pressing
Save.
Resetting to default
 Open the Service page.
 Select Administrator.
 Select Default settings.
A confirmation request appears on the screen asking whether the default setting is
to be restored and whether all user data is to be deleted.
 In case the user data is not to be deleted: Press No.
 In case the default setting is to be restored: Press Yes.
The device initializes, the setting will be restored to default.
Light scenes will be deleted (names and values).
Timer data will be deleted.
Selected colour scheme and basic brightness will be reset.
Fault messages will be deleted.
Calibration data will be reset to the standard setting.
The function will be logged in the past events memory.
Project data and passwords are not affected when restoring the default setting.
GB
29