Start / Stop - Texas EC 2600 Bedienungsanleitung

6. Start / stop

Important. Do not use the machine at very high rotations (throttle) for the first 10 hours. All
bolts and nuts must be tightened after 2 hours use.
Press the ON/OFF switch to I.
ON = I, OFF = 0
Press the primer 6 times until no more air is seen in the re-
turn pipe. (This is not necessary if the engine is warm).
Activate the choke. (This is not necessary if the engine is
warm).
Pull the recoil cord until the engine starts. Press down the
choke handle to open position.
It is important to follow the recoil cord back with your hand
and not let it jump back by it self.
Leave the engine to run for 10 seconds before using the ma-
chine.
Adjust the speed using the throttle.
The engine is turned OFF by pressing the ON/OFF
switch to 0.
www.texas.dk
16