marposs E86N Bedienungsanleitung Seite 84

ENGLISH
Aligning the system
9. Fit the probe finger (see "Fitting the probe finger").
10. Align the centre of the finger ball with the taper axis using the four special nuts (Q). The maximum movement allowed in the four
directions is 1.7 mm.
Example:
Finger ball movement towards "-X" —> loosen (Q1) and tighten (Q2).
Do the same for the other directions.
11. Once the system is aligned, lock the adjusting unit; insert and tighten the two locking screws (R).
Figure 12-4
84
R
R
E86N- Touch system with radio transmission