Programming The Interface - Marposs E86N Bedienungsanleitung

ENGLISH
10.1

Programming the interface

Switch to programming mode and select the type of programming "I" with the "Select" and "Enter" keys to edit one or more of the
following values:
Note: after you have confirmed the last data item you exit programming.
However, you can exit programming at any time by holding down the <ENTER> key for longer than 2 seconds, cancelling the
current sequence.
72
> 2 seconds
Channel entry:
TENS
Channel entry:
UNITS
Probe 1 output polarity:
P1C= N.C. OUTPUT
P1O= N.O. OUTPUT
Probe 1 output functionality:
P1P= PROBE STATUS
P1S= SKIP
Probe 2 output polarity:
P2C= N.C. OUTPUT
P2O= N.O. OUTPUT
Probe 2 output functionality:
P2P= PROBE STATUS
P2S= SKIP
LOW BAT output mode:
LbC= N.C.
LbO= N.O.
PROBE error output:
PE0= Probe at 0 (home)
PE1= Probe at 1(deflected)
START signal:
S= Standard
P= Pulse
r= retrigger
START input:
L= low current 15V-0.5mA
H= normal current 24V-4mA
Remote display on base st.:
0= disabled
1= enabled
Auto. ch. programming:
0= disabled
1= enabled
Number of
switch ON/switch OFF attempts
Confirm data programmed:
0= not confirmed
1= confirmed
E86N- Touch system with radio transmission