Programming The Transmitter - Marposs E86N Bedienungsanleitung

10.2

Programming the Transmitter

Switch to programming mode and select the type of programming "P" with the "Select" and "Enter" keys to edit the following values one
at a time:
> 2 seconds
Note: after confirming the last data item you exit programming and the transmitter is deactivated.
However, you can exit programming at any time, by holding down the <ENTER> key for longer than 2 seconds, cancelling
the current sequence.
∗
( )
Note:
depends on the type of transmitter:
- for a transmitter with radio activation, the activation mode parameter is set to radio activation and the switch off time
value is <5>, corresponding to 2'14"
- for a transmitter with mechanical activation, the activation mode parameter is set to mechanical activation and the
switch off time value is <8>, corresponding to an infinite switch off time.
mida
Channel entry:
TENS
Channel entry:
UNITS
Identification code:
(A, B, C, D)
Activation mode:
0= Radio
1= Mechanical
Operating time:
0= 4"
1= 8"
2= 17"
3= 34"
4= 1'7"
5= 2'14"
6= 4'28"
7= 8'57"
8= ∞
Timer Rettriggering:
0= Disabled
1= Enabled
Confirm data programmed:
0= do not confirm
1= confirm
75