Quax INDIGO 54 03 55xx-3D Bauanleitung Seite 37

INDIGO
54 03 55xx-3D
Step 6 : Use the upper bar EB5, two wooden dowels F and two eccentrics H
Push a wooden dowel (F) into the drillings on the sides of the upper slat (EB4). Push an eccentric (H) into
the holes on the ends of the upper bar.
Step 7 : Use both sides EB2 LH and EB2 RH, the sliders J LH and J RH, twelve bolts I, four wooden
dowels F, ten connectors G, four eccentrics E and six eccentrics H
Position the sliders (J) on the provided drillings of the side panels (EB2 LH and EB2 RH). Fix each slider
with two bolts (I) according to the diagram in detail (third hole on the
(G) into the holes at the back of a side. Tighten three connectors (G) into the holes in front of the side.
Push two wooden dowels (F) into the holes provided on top of the side. Push two eccentrics (E) into the
drillings provided at the bottom of the side. Push three eccentrics (H) into the drillings provided at the top
of the side. Repeat with the other side.
Commode met drie laden
Kommode mit drei Schubladen
Commode avec trois tiroirs
Chest of three drawers
slider). Tighten two connectors
Quax Quax
First dreams First dreams
® ®
First steps First steps
37