Technical Specifications
•
Analog amplifier with high current micro-processor controlled switching power supply
•
Double output terminal for dual voice coil subwoofer, 1 Ω stable
•
Preamplifier with very low noise
•
Additional preamplifier output „Line Out" for additional amplifier
•
Gain control „Level" infinitely variable
•
Subwoofer level and phase control over cable remote infinitely variable
•
Reversible switch-off device with thermal monitoring
•
Safety switch-off device with DC current to loudspeakers
•
Integrated flat fuse 3 x 35 A in accordance with DIN-standard, replaceable from outside
•
Safety switch-off device with loudspeaker short circuit and under impedance of loudspeaker
•
Soft start remote muting for suppression of switch-on noise
•
Low power requirements for remote muting electrical circuits
•
Palladium-plated 35 mm² power and 10 mm² loudspeaker connection.
•
High-tech structure in semi SMD building method with low coupling wiring
•
Interference-proof certified by European CE standard
Technical Data
Output power
Output power
Output power
Total distortion factor THD+N
Signal-to-noise ratio S/N
Frequency range –3 dB
Input sensitivity line input
Connection impedance
Damping Factor
Operating voltage
Peak current draw
Efficiency
Short circuit protection / Overloading
Temperature monitoring heat sink
Soft start-muting on/off
Dimensions: W x H x D
Weight
Approval
Active Controls:
Low pass
Subsonic Filter
Phase shifter
Remote Control
50 Hz – 5 kHz infinitely variable, 12 dB/Oct.
15 Hz - 500 Hz infinitely variable, 12 dB/Oct.
Phase shifter and gain infinitely variable
6
Germanium One
1 x 500 Watt RMS at 4 Ω
1 x 800 Watt RMS at 2 Ω
1 x 950 Watt RMS at 1 Ω
0.02 % (100 Hz /1 Watt)
>96 dB/A-weighting
1.5 Hz – 50 kHz
250 mV – 6 V
1 Ω, 2 Ω or 4 Ω possible
11 V – 16 V DC
126 A
70 % with 14.4 V DC
Immediate switch off
80° C switch off
1 sec. signal delay
420 x 55 x 235 mm
5,5 kg
0 – 180° infinitely variable
>200
CE