Replacing The Lamp; Closing The Door - Electrolux EK284SA Benutzerinformation

16 www.electrolux.com
Problem
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
Food products prevent that
water flows into the water
collector.
The FastFreeze or Shop‐
ping function is switched
on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function" or " Shop‐
ping function".
Keep the OK button press‐
ed for approximately 10
seconds until a long sound
is heard and display shuts
off for a short time.
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Refer to " Shopping func‐
tion".
to "Installation".
door gaskets. Contact the Authorised
Service Centre.