Getting Started - Beurer AS 50 Gebrauchsanleitung

G
ETTING STARTED
Insert battery/Change battery
If you do not want to insert or change the battery yourself,
please bring it to a watchmaker.
Change the battery in the morning before recording the activ-
ity. This is the only way to ensure that none of the daily re-
cordings are overwritten in the computer software.
At first remove the activity sensor from the belt clip (see chapter "At-
taching the activity sensor", section "Wearing the activity sensor on
your belt/trouser waistband").
The battery compartment of the activity sensor is located on the back
of the monitor. Place the monitor with the front facing downwards on a
soft surface and insert the battery as follows:
Using a coin, turn the lid of the battery
1
compartment anticlockwise until the lid
comes off.
Remove the battery from the battery com-
partment with the aid of a pointed, non-
metallic tool, e.g. toothpick.
Put the battery into the battery compart-
2
ment in such a way that the battery is on
top of the spring underneath the clip (1)
and the positive pole (+) faces upwards.
Check the seal. The seal has to lie flat in
the casing and there must be no visible
damage to it. The impermeability cannot
be guaranteed otherwise.
10