Beyerdynamic Unite TP Kurzanleitung Seite 25

Unite TP – Bodypack Transmitter
3. Insert one or more receivers into the charging slots of
the charger to be paired with the transmitter. You can
also connect another receiver to the charger using the
USB port. Remove all receivers that should not be
paired. If there is no receiver in the charging slots, the
pairing information is stored in the charger. This is used
for later pairing without connecting the transmitter to
the charger.
4. In order to transfer the pairing information from the
transmitter to the receivers in the slots and to the
charger itself for future pairing, press and hold the
"Pair/Reset" button
2 seconds. The status indicator
several seconds if the pairing is successful. The status
indicator will then remain yellow because the pairing
information is now also stored in the charger.
5. If you want to pair other receivers, remove the transmitter
and all receivers from the charger, set the switch
"Pair & Charge" and insert the unpaired receivers into
the charger. The pairing information will be stored
immediately in the unpaired receivers. The status indi-
cator on the receiver will flash yellow rapidly while this
happens.
6. Set the switch
pairing is finished, so that the charger can only be used
for recharging.
7. Switch on the transmitter and one receiver to check that
they have both been paired successfully.
After a few seconds, the status indicator
receiver should light up green and the display
show the channel name of the transmitter.
on the charger for more than
back to "Charge only" when the
will flash yellow for
on the
should
25
to