BOMANN DU 623.3 Bedienungsanleitung/Garantie Bedienungsanleitung, Garantie Seite 19

• Select the fume outlet and set the lever to the
appropriate position, see "Selecting the fume out-
let".
Mounting at the wall Mounting at the wall Mounting at the wall Mounting at the wall
• Mark the necessary holes for the wall mounting by
using the supplied drill template and check them
with a spirit level.
• Drill two mounting holes Ø 8 mm into the wall and
insert the dowel pins (1). Then rotate the mount-
ing screws (2) as far as these stick out about
4 mm from the wall.
• Suspend the hood and tighten the screws through
the hood body. Check the secure fitting and hori-
zontally position.
Mounting below the wall u Mounting below the wall unit Mounting below the wall u Mounting below the wall u
• Hold the hood to the specified cabinet position
and draw the drilling points from the inside of the
unit corresponding to the four screw holes. Check
them with a spirit level.
• For extraction mode, you must also create a feed
through of approx. Ø 130 mm in the base of the
unit.
• If the mains cable is fed through the unit, a feed
through also must be provided.
• Drill four mounting holes of Ø 4 mm through the
base of the unit. Screw in the appliance with the
screws including washers (3) under the wall unit
and tighten the nuts (4) through the hood body.
• For extraction mode insert the connecting piece
with non-return valves (5) from above onto the air
outlet. Thereto a flexible extraction hose (not sup-
plied) with an inner diameter of Ø 120 mm must
be fitted and connected to the outside by an ex-
traction vent.
• For recirculation mode close the air outlet by put-
ting on the cover (6).
• Reinstall the aluminum grease filter.
nit nit nit
Installing the activated carbon filter mat for recircula- a- a- a- Installing the activated carbon filter mat for recircul
Installing the activated carbon filter mat for recircul Installing the activated carbon filter mat for recircul
tion mode tion mode
tion mode tion mode
• Remove the aluminum
grease filter (1).
• Insert the previously fitted
carbon filter mat parts onto
the grease filter and fix the mat parts each with
two metal struts (2) (supplied with the carbon filter
mat).
• Reinstall the aluminum grease filter with fixed
carbon filter mats.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock shock! shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
19
electric electric electric