Inserting A Bit; Removing The Bit; Led Worklight; Replacing The Worklight Battery - Westfalia 86 40 91 Originalbetriebsanleitung

Operating

Inserting a Bit

Push forward metal collar and insert
any 1/4 in. hex shank accessory
(Fig. 2). Release the collar to lock the
accessory in the bit connector.

Removing the Bit

Push forward the metal collar to
release the accessory from the bit
connector.
Fig. 2

LED Worklight

This driver has a LED worklight (1)
built into the head of the tool (Fig. 3).
Turn the LED bulb towards the
direction of the connector to turn on.
1
The light will remain on while it is in
the same direction as the connector.
To turn off the light, turn the LED bulb
towards the battery compartment (2).

Replacing the Worklight Battery

Remove the battery cover (2) with a
2
slight left turn of a screwdriver (Fig. 3)
and replace the battery with a new
one (CR927). Please observe correct
polarity, the positive pole (+) of the
battery must point to the battery
compartment cover.
Fig. 3
14