Instar IN-5905HD Bedienungsanleitung Seite 25

01 - Antenna Connector
02 - MicroSD Card Slot
03 - Infrared LEDs
04 - Lens
05 - Photosensor
06 - Audio output
07 - Alarm input
08 - Alarm output
09 - Audio input
10 - WPS / Reset
11 - Power Connector
12 - Network Port
13 - Camera Label
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Off
Go to http://install.instar.com
RP-SMA WiFi antenna connector (incl. 3dB antenna)
Slot for MicroSD/SDHC cards (max. 32GB - 8GB included)
(already installed inside the camera)
5 High-Power IR LEDs (nightvision @ 850nm)
4mm CS-Mount lens with a ~90º diagonal field of view
Twilight switch for IR LEDs
Chinch-connector for optional active loudspeakers
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
Chinch-connector for optional active speakers
3 seconds for quick WiFi setup / 15-20 seconds for reset
12V / 2A DC - Plug Ø : 2,1mm (in) / 5.5mm (out)
RJ45 LAN-port / connector for Cat5e LAN cable or higher
Please refer to below 4.3 for Status LEDs
P2P ID, LAN MAC address and serial number (located at the
backplate)
Green LED
-
-
Data transfer through LAN
No network cable connected
or in WiFi mode
Orange LED
Network cable is connected or
in WiFi mode
-
-
Network cable is not connected
correctly
6-EN