Commissioning Your Sxt Scooter - SXT 1000 TURBO Benutzerhandbuch

E
1. Carefully unpack your SXT scooter and remove any packaging material attached to the scooter.
2. Install the front wheel in the folded state. Mount the wheel with the spacers and the axle with the supplied tool. (see picture 1- 4)
3. To unfold the scooter, push the locking lever down with one hand while gently pulling up on the handlebar with the other
hand.
MAKE SURE that your head is not in the area of unfolding parts! (see picture 5)
4. Place the handlebar completely vertically until it clicks into place.
5. Now put the handlebars on the pole, align them straight and tighten the screws with a tool.
Pay attention to correct installation - the throttle must be in the direction of travel on the right side. (see picture 6)
6. Check the brake levers for tightness - if they are loose, tighten them also in a position suitable for you. Do not pull,
bend or twist the brake cables.
7. Place the supplied battery pack in the cavity under the footboard and connect it to the power supply.
Please note: If you have a version with a lead-acid battery, please first insert the included flat fuse
holder on the red cable.
When connecting the battery and control unit or when inserting the blade fuse, sparking may occur.
This is normaly and not a cause for concern.

3. Commissioning your SXT scooter

3 0
into the