First Use; Control Panel - Zanussi ZFP18400WA Benutzerhandbuch

First Use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand new product,
then dry thoroughly.

Control panel

The control panel that controls the temperature
inside the freezer compartment is located inside
the freezer.
: Eliminate alarm sound button.
Alarm : extensive temperature indicator.
Power : electrical power indicator.
Super : Super Freeze indicator.
Super Freeze : Super Freeze button.
SUPER FREEZE (Button)
If you need the temperature inside the freezer to
drop quickly, please press this button and indica-
tor of super will be on. The unit runs in Super
Freezer.
If you need the appliance to stop the mode of
Super Freeze, please repress the Super Freeze
(button), the indicator of super shuts off.
Attention!
At super freeze mode, the freezer will automati-
cally quit super freeze mode after 48 hours, the
super indicator will shut off simultaneity.
64
EN
ZFP18400WA_2015.indb 64
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
Mid
Alarm
Cold Colder
ALARM FOR FREEZER
When powered, and the inside temperature has
reached the higher degree ≥-10°C, then the
indicator starts to work. When temperature
≥ -10°C, The indicator light begins to flash, and
at the same time, the alarm sounds 3 times per
10 seconds. After 2 minutes, the alarm will au-
tomatically stop, and the Excessive temperature
indicator will be on but will stop flashing. When
temperature < -10°C,Excessive temperature indi-
cator shuts off.
freezer, press
and the excessive temperature indicator is on but
no flashing.
Important! - Normally we advise you select set-
ting of Mid, if you want the temperature warmer
or colder please turn the knob to lower or higher
setting accordingly. When you turn the knob to
lower which can lead to the more energy-saving.
Otherwise, itwould result the high energy-con-
suming.
Important! - High ambient temperatures (e.g.
on hot summer days) and a cold setting on the
temperature regulator (position Colder) can
cause the compressor to run continuously or
even non-stop!
Reason: when the ambient temperature is high,
the compressor must run continuously to main-
tain the low temperature in the appliance.
Power Super Super Freeze
: (button) During the alarm of
: the alarm sound is stopped,
2016-01-04 16:18:45