Control System Activation (Only For Sauna Module); Using The Control System - Preliminary Operations - Jacuzzi sasha Installations- Und Gebrauchsanleitung

CONTROL SYSTEM ACTIVATION (only for SAUNA module)

NOTE: this procedure does not need to be carried out with the "ham-
mam" module.
■ Check that the sauna area is suited to its use (steamer full with
water where a bio sauna or Roman sauna is required, absence of
potentially hazardous conditions, etc., see the Sasha user manual).
■ Check that the ON/OFF key lights up white and press it (it
lights up blue).
1
■ Press one of the relative programme keys: the key will light up
blue and, at the same time, the "thermometer" symbol will flash.

USING THE CONTROL SYSTEM - preliminary operations

■ Open the programme ("browser") to navigate the Web and
type the indicated address in the navigation bar:
NOTE: the numbers in the address may not correspond with those
displayed as they may have been changed during the configura-
tion stage; refer to the relative chapter and the network admin-
istrator.
■ Exit the sauna area within 20 seconds, ensure you close
the door fully.
After this time, the ON/OFF key on the keypad will flash brief-
ly and the "Remote" key on the display will light up green: Sasha
can now be managed from the remote control system (the key-
pad is locked).
NOTE: audio system (where installed) controls and the warning key
remain available on the keypad.
Do not open the door during the specified 20 seconds,
otherwise the procedure will be interrupted (the ther-
2
mometer symbol will turn itself off).
The above mentioned procedure must be carried out
on all sauna modules present; where there are multi-
ple control systems, activation will be indicated on the
respective display.
■ A welcome screen, similar to the one shown, will appear.
Next to the Jacuzzi logo, the terms which were inserted in
the"installation name" and "system name" fields respectively,
will appear (see Chapter "Web-based access configuration"). These
terms are also repeated at the centre of the screen.
The time appears on the top right.
The sauna and/or hammam modules are listed to the left of
the display (e.g. Sauna 1 and Hammam 1).
NOTE: messages in red mean that connection attempts have failed;
see the "Troubleshooting" chapter.
■ To select the desired module, click on the arrow next to
the module name itself (e.g. the arrow key next to the term
Sauna 1).
The respective control displays are shown below.
29