Entering New Timings; Power Saving Function; Plug And Play; Use Of The Tilt-Swivel - Sony CDP-100ES Bedienungsanleitung

Entering New Timings

When using a video mode that is not one of the factory
preset modes, some fine tuning may be required to optimize
the display to your preferences. Simply adjust the monitor
according to the preceding adjustment instructions. The
adjustments will be stored automatically and recalled
whenever that mode is used.

Power Saving Function

This monitor meets the power saving guidelines set by the
International ENERGY STAR Program as well as the more
stringent NUTEK guidelines. It is capable of reduced power
consumption when used with a computer equipped with
Display Power Management Signaling (DPMS). By sensing
the absence of the sync signal coming from the computer, it
will reduce the power consumption as follows:
CAUTION: The Power Saving function will automatically
put the monitor into Active-off state if the power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
Power
State
consumption
110 W
Normal
(100ES/100EST)
1
120 W
operation
(200ES/200EST)
Standby
(1st step of
2 15 W
power saving)
Suspend
3 (2nd step of 15 W
power saving)
Active-off
(3rd step of
4 8 W
power saving)
≈ 0 W
5 Power-off
8
Recovery u POWER
time indicator
––
green on
Orange and
approx.
green flashes
3 sec.
alternately
Orange and
approx.
green flashes
3 sec.
alternately
approx.
Orange on
10 sec.
––
off

Plug and Play

This monitor complies with DDC
the Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B host system is connected, the monitor
automatically switches to the DDC2B communication.
DDC TM is a trademark of the Video Electronics Standard
Association.

Use of the Tilt-Swivel

With the tilt-swivel, this unit can be adjusted to be viewed at
your desired angle within 180˚ horizontally and 20˚ vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands.
15°
90°
5°

Damper Wire

Using a white background, very thin horizontal stripes on
the screen are visible as shown on the illustration. These
stripes are damper wires. These wires are attached to the
aperture grille inside the Trinitron tube and are there to
dampen vibrations of the aperture grille in order to prevent
them from influencing the picture quality.
Damper wire
TM
1 and DDC2B, which are
90°
Approx. 6 cm
(CPD-200ES/
200EST only)
Approx. 6 cm