Connecting The Disk Unit - Sony RMO-S594 Bedienungsanleitung

Connecting the Disk Unit

You can hook up a maximum of seven SCSI
peripheral devices to a single host computer
through its SCSI bus.
Use either of the following Sony SCSI cable
(sold separately) to connect the disk unit.
• MOA-C08 (80 cm, full pitch⇔ full pitch)
SCSI cable
(sold separately)
10
Chapter 2 Getting Started
RMO-S594-DW/S591-DW Magneto-Optical Disk Unit
A B C D E F G H
1
SCSI ID
0
SCSI CONNECTOR
to SCSI connector
SCSI cable
(sold separately)
to another to the host computer or
SCSI device another SCSI device
Fig 2-2: Connecting the RMO-S594-DW/S591-DW
Notes:
• Before connecting the disk unit, be sure to turn
off the disk unit and all other devices on the
SCSI chain.
• If the disk unit is the last device on the SCSI
chain, set the function switch F on the rear
panel to "1" to turn on the internal terminator.
When it is not the last device, make sure that the
terminator is off (function switch F is set to
"0").
• The total length of the SCSI cables connected to
a SCSI chain must not exceed six meters (19
feet 8 1/4 inches).
AC IN
F.GND
to AC IN
connector
AC power cord
(supplied)
to an AC outlet