Ironing Without Steam; Auto Shut-Off - Siemens slider SL22 Gebrauchsanleitung

of steam so that the steam reaches even deeper
into the fabrics.
1. Set the setting selector (10) on "• ••"
2. Briely press the steam shot button (16*) on the
top of the handle.
or (model dependent)
Press the steam release button (15) on the
bottom of the handle two times in quick
succession (double-click).
Remarks:
• It is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the "pulseSteam" function for the irst time.
The water drops will disappear after you have
used the function for some time.

Ironing without steam

Begin ironing but without pressing the steam
release button.
C
Vertical steam
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
• Never direct the steam jet at garments that
are being worn.
• Never aim the steam at people or animals.
1. Set the temperature to the "•••" setting.
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the
steam release button (15 or 16*).
"Intelligent steam" function
(Model dependent)
This system has intelligent steam control, which,
after releasing the steam release button (15),
provides a small amount of additional steam.
The additional steam can always be stopped by
briely pressing the steam release button once
again.
Energy saving
"eco" button
(model dependent)
If the "Energy saving" button (8) is switched on,
you can save up to 25% of the energy and 40%
of the water consumption (*), and still achieve
good results when ironing most of your garments.
It is advisable to use the normal energy setting
only for thick and very wrinkled fabrics.
(*) In comparison to the maximum setting.
Note: If you work with the "Energy saving"
function, the variable steam regulation and
temperature regulation can still be used as
recommended.

Auto shut-off

(Model dependent)
If during ironing, the steam release button
(15-16*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The "auto shut-off" pilot lamp (9) will lash when
auto shut-off has been activated.
To switch the steam station back on, press the
steam release button again.
Fabric protection
D
soleplate cover
(Model dependent)
The fabric-protection soleplate cover (19*) is
used for steam-ironing delicate garments at
maximum temperature without damaging them.
Use of the soleplate cover also does away with
the need for a cloth to prevent shine on dark
materials.
It is advisable to irst iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it its tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from our customer service or from our
website
Accessory code
(After-sales)
571510
Name of accessory
(online shop)
TZ20450
17
S IEMENS