Using Bluetooth Power On; Software Update - Samsung MM-J430D Bedienungsanleitung

Using Bluetooth Power On

When the product is turned off, you can connect
your smart device to the product via a Bluetooth
connection to turn it on.
1 . Press and hold the SOURCE button to set
the Bluetooth Power On function on. ON-
BLUETOOTH POWER appears on the
display.
2 . When the product is off, connect your smart
device to the product via Bluetooth. (For
information on Bluetooth connections, refer
to your smart device's manual.)
• The Bluetooth device must have been
paired with the Micro Component before.
3 . When the connection is complete, the product
turns itself on automatically in Bluetooth
mode.
• Select the desired music to play from your
smart device.
| NOTE |
\ Press and hold the SOURCE button to turn
the Bluetooth Power On function on or off.
Each time you press and hold this button, the
Micro Component displays ON -BLUETOOTH
POWER ; OFF-BLUETOOTH POWER on its
display.

Software update

Samsung may offer updates for the product's sys-
tem firmware in the future.
If an update is offered, you can update the firmware
by connecting a USB device with the firmware
update stored on it to the USB port on your product.
Note that if there are multiple update files, you must
load them onto the USB device singly and use them
to update the firmware one file at a time.
Please visit samsung.com or contact the Samsung
Call Center to receive more information about down-
loading updates files.
• Select USB function, insert a USB device
containing the firmware update into the USB port
on the main unit.
• Updating firmware may not work properly if audio
files supported by the product are stored in the
USB storage device.
• Do not disconnect the power or remove the USB
device while updates are being applied. The main
unit will turn off automatically after completing the
firmware update.
• After the update, all settings are reset to their
factory default settings. We recommend you write
down your settings so that you can easily reset
them after the update.
If the firmware fails to update, we recommend
formatting the USB device in FAT16/FAT32 and
trying again.
• Once the software update is completed, turn on
the product with no disc inserted. The "NO DISC"
message appears on the display. Press and hold
the STOP button on the main unit for longer than
5 seconds. "INIT " appears on the display and the
unit powers off. The upgrade is complete.
• Do not format the USB device in the NTFS format.
The product does not support the NTFS file
system.
• Depending on the manufacturer, some USB
devices may not be supported.
• The product has a DUAL BOOT function. If the
firmware fails to update, most functions will
become inoperable and "UPGRADE FIRMWARE"
will appear on the display. Update the firmware
again.
|
27
English