Before Use; Bringing Into Use; Attaching The Spray Tube Without The Extension Tube; Attaching The Spray Tube With The Extension Tube - FLORABEST Z30597 Bedienungsanleitung

Safety advice / Before use / Bringing into use
Do not use the product for
drinks!
Fill the device only with liquids at
temperatures of 0 - 40 °C.
©

Before use

CAUTION! Check that the device is
functioning properly! Check the pressure
sprayer before each use to ensure that it
is free of visible damage and is func-
tioning safely. To do this, carry out the
following tests and inspections:
Check the pressure sprayer for
visible signs of damage
Check the container
of damage.
Check the suction hose
signs of damage.
Check the carrying strap
signs of damage.
Check connections
Check that the hose connections are fitted
tightly.
Check that the pipe connections are fitted
tightly.
Check that the pressure sprayer is
tight and leak-free
Pump the empty pressure sprayer to
approx. 2 bar.
The pressure must not fall more than ap-
prox. 0.5 bar in a space of 30 minutes.
10 GB/IE
Check operation of the safety
valve
©
©
for visible signs
5
for visible
18
for visible
6
©
Pump the pressure sprayer to approx.
2 bar.
Pull the safety valve
3
You must be able to hear the pressure
escaping.

Bringing into use

Attaching the spray tube
without the extension
tube (Fig. B)
Turn the union nut anticlockwise to
16
release it from the handle
spray tube into the handle
12
far as it will go.
Tighten the union nut
16
clockwise.
Note: You can also extend the spray
tube by turning the lock nut
12
clockwise to release it and then pulling
out the extension. Then retighten the
lock nut (see Fig. B).
10
Attaching the spray tube
with the extension tube
(Fig. C)
Loosen the union nut
15
ing it anticlockwise. Insert the spray
tube into the union nut
12
Tighten the union nut
15
clockwise.
Insert the extension tube
union nut .
16
Tighten the union nut
16
clockwise.
up to the stop.
. Push the
17
as
17
by turning it
anti-
10
slightly by turn-
.
15
by turning it
into the
9
by turning it
®