Led Functions Of Charger - EGO CHX5500E Bedienungsanleitung

LED FUNCTIONS OF CHARGER

EN
LED INDICATOR BACKPACK BATTERY
Defective
Over tem-
perature
Normal charging
Rapid charging
Fully
charged
Successful self-
—
inspection
: On : Off
CHARGING A HOT OR COLD BATTERY PACK
If the battery pack is out of the normal temperature range,
3# LED will shine red. When the battery pack cools down
to approximately 57°C or warms to more than 3°C, the
charger will automatically begin charging and the 3 LEDs
will sequence normally.
DEFECTIVE BATTERY PACK OR CHARGER
Once the charger connects to a power supply, the charger
will start self-inspection immediately.
1. If the self-inspection reaches a failure, all the LEDs
will not blink or shine.
Notice:
Try and reinsert the power cord into the charger
and power supply in sequence. If the LEDs still read
"failure" a second time, contact the EGO center to repair
your charger.
2. If the charger passes the inspection, 3 LEDs will shine
for 1s simultaneously, which means the charger can
be used to charge the battery pack. While charging,
if the charger defects a problem, 3# LED will begin
flashing red or all the LEDs will turn off.
6
56 VOLT CHARGER — CHX5500E
LED ON THE CHARGER
1# LED (GREEN) 2# LED (GREEN) 3# LED (RED)
Normal
charging
Rapid
charging
Normal
charging
Rapid
charging
: Flashing
Battery pack or charger is
defective
Charging will begin when
battery pack returns to normal
temperature
Charging will begin when
battery pack returns to normal
temperature
4A Charging
8A Charging
Charging is completed
Charging is completed
The charger could be used to
charge the battery
◾
If registering as defective, remove and reinsert the
plug of battery pack into the charger. If the LEDs
still read "defective" a second time, try charging a
different battery pack.
◾
If a different battery pack charges normally,
dispose of the defective battery pack (refer to the
instructions in the battery pack manual).
◾
If a different battery pack also indicates
"defective", reconnect the charger to power supply
again until the red 3# LED goes out. If all 3 LEDs
still keep off or 3# LED flash red, the charger may
be defective.
WARNING:
It is not recommended to attempt
charging while the charger confirmed as a defective one,
it can cause electric shock or even serious injury.
WALL-MOUNT HOLES
The charger has hanging holes for convenient storage.
Install screws in the wall 76mm apart. Use screws suffi-
ciently strong to hold the combined weight of the charger
(approximately maximum 1.6 kg).
ACTION