EINHELL GH-BC 33-4 S Bedienungsanleitung Seite 8

S-Hinweise_Motorsense_GH-BC_33-4_S_SPK7__ 13.05.13 15:51 Seite 8
GB
11. DO NOT ADD, REMOVE OR ALTER ANY
COMPONENTS OF THIS PRODUCT. Doing so
could cause personal injury and/or damage the
unit voiding the manufacturerʼs warranty.
12. DO NOT operate your unit near or around
flammable liquids or gases whether in or out of
doors. An explosion and/or fire may result.
13. DO NOT USE ANY OTHER CUTTING TOOLS.
For your own safety only use the accessories
and additional equipment specified in the
operating manual or recommended or specified
by the manufacturer. The use of tools or
accessories other than those recommended in
the operating manual or catalog may place you
in danger of personal injury.
Safety when handling the blade
1. FOLLOW ALL WARNINGS and instructions for
using the machine and for installing the blade.
2. The blade may suddenly jump away out of
control if it comes up against objects which it
cannot cut through. This may result in the
amputation of arms or legs. Keep onlookers
and animals at least 15 m away from where you
are working. If the machine strikes a foreign
body, stop the engine immediately and bring the
blade to a standstill. Check the blade for signs of
damage. Always replace the blade if it is bent or
torn.
3. THE BLADE WILL THROW UP OBJECTS AT
HIGH SPEED: This may cause blinding or
injuries. Always wear eye, face and leg
protection. Remove all objects from the working
area before using the blade. Keep other people
and animals at least 15 m away from the
machine in all directions.
4. Check your machine and other equipment
carefully for signs of damage. Do not use the
machine unless all the blade mountings have
been installed correctly.
5. THE BLADE WILL SLOW DOWN AND STOP IF
YOU RELEASE THE THROTTLE VALVE (gas
lever). While it is slowing down, the blade can
still cut you or onlookers. Before you carry out
any work on the blade, switch off the engine and
make sure that the blade has stopped.
6. DANGER ZONE WITH A DIAMETER OF 15
METERS. Onlookers may suffer blindness or
injuries. Keep onlookers and animals at least 15
m away from where you are working.
7. During transport, mount the edge protector on the
blade in order to prevent injury through cutting on
sharp edges.
8