Troubleshooting Guide; Technical Data; Declaration Of Conformity - Truma S 5004 Gebrauchsanweisung Und Einbauanweisung

Maintenance
Cleaning the inspection window
Clean the inspection window with water (without
cleaning agent). Use a soft sponge, woollen cloth
or chamois leather. Never use sharp objects or solvents to
remove stains.
Fuses
Depending on the variant, a fuse (3.15 AT) is installed in the
supplied connector cable. Only replace the fuse with one of
the same type.

Troubleshooting guide

Fault
– No flame or glow.
– No sound.
– The front case with flame
effect does not react to
switching commands from
the remote control.
– The remote control's
function display does not
acknowledge any button
pressing.
– The front case with flame
effect does not work.
If these actions do not remedy the problem, please con-
tact Truma Service.
8
Cause / Remedy
– Increase the brightness.
– Turn up the volume.
– Point the remote control
at the IR receiver when
performing switching
commands.
– Check that the batteries in
the remote control are in
perfect condition.
– Check the supply line and
make sure that the plug is
inserted correctly.
– Check the fuse in the vehi-
cle's power supply / con-
nector cable.
– Check whether the supply
battery is in perfect condi-
tion and is fully charged.
– Perform a reset. To do this,
interrupt the power supply
for at least 20 seconds.
Disposal
The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.
In other countries, the relevant regulations must be observed.

Technical data

SELV power supply (Safety Extra Low Voltage)
12 V
Protection class
III
Power consumption
12 W
Quiescent current
< 1 mA
Weight
approx. 2.8 kg
Subject to technical changes.

Declaration of conformity

The appliance has been tested by the DVGW and has been
passed to carry the type approval number E1 122R-000362,
E1 10R-046531 and the CE mark with the approval number
CE-0085CM0288. (Declaration of conformity – see operating
instructions of relevant heater)
The CE product identification number of the heater remains
valid.