Operation - Oase ProMax MudDrain 11000 Gebrauchsanleitung

Manual mode
The pump remains permanently switched
on if the float switch is set vertically and
the cable points downward.
N O T E
The pump can run dry in manual mode.
• Switch off the pump when the minimum
water level is reached.
• Running the pump dry increases wear.
 D
• Move the handle into the horizontal po-
sition and push the cable directly at the
transition to the float switch into the ca-
ble clip such that the float switch is in a
vertical position.
Installing the pump
 H
• Install the pump in the water in a hori-
zontal and stable position.
• If it needs to be lowered into a well or a
shaft, fasten a rope to the handle. Do
not carry it by the power connection
cable.
• Install the pump so that intake of dirt
particles larger than the permissible
grain size is avoided (a larger distance
from the bottom may be necessary). Ot-
herwise the intake opening will be blok-
ked.
• Ensure that the float switch can always
move freely.
14

OPERATION

W A R N I N G
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
• Only connect the pump to the power
supply when there are no persons in or
reaching into the water.
• Before stepping into or reaching into the
water, switch off all units located in the
water.
Switching on the unit
• Insert the power plug into the socket.
– The pump is ready for operation.
– The pump will start up as soon as the
level of the water reaches the switch-
on height.
Switching off the unit
• Disconnect the power plug.
– When the pump is switched off, resid-
ual water in the hose may flow back
and out of the pump intake.
N O T E
Do not use the unit for long-term opera-
tion. Otherwise this will impair the operat-
ing life of the unit accordingly.
N O T E
Rinse out the pump with clean water after
use.
ProMax MudDrain 7000/11000/14000/20000