HQ Power VDPC174 Bedienungsanleitung Seite 8

4. Press the bank UP / DOWN button and scroll to the step you wish to insert the step after.
5. Press the MIDI / REC button. The segment display will read the step one step higher than
before.
6. Tap the TAP / DISPLAY button again. The LCD shows the current chase, scene, and bank.
Create a desired scene and record it as a new step or select a previously programmed scene to
add to the chase.
7. Once you have selected the scene you wish to add, press the MIDI / REC button again. All
LEDs will flash three times indicating the new step has been inserted into the chase.
• Deleting a Step
1. Enable the PROGRAM mode.
2. Select the chase that contains the step you wish to delete.
3. Press the TAP / DISPLAY button, the LCD shows the current step.
4. Press the bank UP / DOWN button and scroll to the step you wish to delete.
5. Press the AUTO / DEL button to delete the step. All LEDs will flash three times indicating the
requested operation has been performed.
• Deleting a Chase
1. Press the button corresponding to the chase you wish to delete.
2. Press and hold down the AUTO / DEL button while holding down the CHASE button. All LEDs
will flash three times indicating that the requested operation has been performed.
• Deleting All Chases
1. With the power off, press and hold down the AUTO / DEL and bank DOWN buttons at the same
time.
2. Reapply the power and all chases should be cleared.
e. Joystick / Channel Selection
• Setting-Up the Joystick
1. Press and hold the PROGRAM button until the LED is lit.
2. Press and hold the MODE and FINE buttons simultaneously. The ASSIGN LED should light. If
the reverse LED lights, press FINE and MODE again to enter the ASSIGN mode.
3. Use the bank UP and DOWN keys to select the axis you wish to assign (pan or tilt).
4. Use the TAP / DISPLAY button to select 16 or 8-channel mode.
5. Press the button corresponding to the scanner you wish to assign.
6. While holding the MODE button press the scene number corresponding to the slider which
controls the movement (example: If the pan is controlled by slider number 4, press and hold
the MODE button while tapping scene button 4).
7. When finished press the MODE and FINE buttons simultaneously again to exit ASSIGN mode.
• Reversing the Joystick Movement / DMX Channel
1. Enable the PROGRAM mode.
2. Press the FINE and MODE buttons to enter ASSIGN mode. Press the FINE and MODE buttons
again to enter REVERSE mode. The reverse LED lights up indicating the REVERSE mode is
active.
3. Use bank UP / DOWN button to change between the pan and tilt. The corresponding LED lights
indicating this selection.
4. Press the TAP / DISPLAY button to change between 8-channel and 16-channel mode.
5. Press the SCANNER button to select the scanner.
6. While holding the MODE button, press the corresponding SCENE button of the channel you
wish to reverse (example: If you are reversing the scene on one scanner, once you verify that
you are in reverse mode and the tilt LED is lit, check to see which slider the tilt control is on.
Hold the MODE button and press the SCENE button that is same as the slider number for tilt
(slider 5 / scene 5)).
7. Continue steps 3 to 7 as needed. You may reverse a maximum of 48 channels for 12 scanners.
15.03.2010
VDPC174
8
Rev 01
©Velleman nv