HQ Power VDPC174 Bedienungsanleitung Seite 7

• Copying Scanner Settings
This setting allows you to copy the settings of one scanner to another.
1. Press and hold down the scanner button you wish to copy.
2. While holding down the button, tap the button of the scanner you wish to copy the settings to.
• Copying a Scene
1. Enable the PROGRAM mode.
2. Tap the bank UP / DOWN button to select the bank containing the scene you wish to copy.
3. Select the scene you wish to copy by pressing its scene button.
4. Using the bank UP / DOWN button select the bank you wish to copy the scene to.
5. Tap the MIDI / REC button.
6. Tap the scene button you wish to copy the scene to.
• Deleting a Scene
1. Enable the PROGRAM mode.
2. Press the desired SCENE button to select the scene you wish to delete.
3. Press and hold down the AUTO / DEL button. While holding the button, tap the SCENE button
that corresponds with the scene you wish to delete.
4. When the programmed scene is deleted, all DMX channel values will be set to 0.
• Deleting All Scenes
1. With unit switched off, press and hold down the PROGRAM and bank DOWN buttons at the
same time.
2. Turn the unit back on and all scenes should be cleared.
• Copying a Bank of Scenes
1. Enable the PROGRAM mode.
2. Tap the bank UP / DOWN button until you reach the bank you wish to copy.
3. Tap the MIDI / REC button.
4. Tap the bank UP / DOWN button to select the bank you wish to copy to.
5. Tap the MUSIC / BANK COPY button, all LEDs will briefly flash three times indicating the
function has been completed.
6. Press the PROGRAM button for three seconds to exit PROGRAM mode.
d. Chases
• Programming a Chase
Scenes must have been programmed in order to program a chase. This function allows you to
cycle through up to 240 scenes in a preselected order. It is recommended to delete all chases in
the controller before programming chases for the first time. See "Deleting All Chases".
1. Enable the PROGRAM mode.
2. Tap the CHASE button to select the chase you wish to program.
3. Select a desired scene from the bank that has scenes stored inside it.
4. Tap the MIDI / REC button.
5. Repeat steps 3 to 4 until all desired scenes have been entered.
• Inserting a Bank of Scenes into a Chase
1. Enable the PROGRAM mode.
2. Select the chase you wish to program.
3. Use the bank UP / DOWN key to select the bank of scenes you wish to copy.
4. Tap the MUSIC / BANK COPY button.
5. Tap the MIDI / REC COPY button. All LEDs will flash three times indicating that the requested
operation has been performed.
• Adding a Step
1. Enable the PROGRAM mode.
2. Press the corresponding button to the chase you wish to add a step to.
3. Press the TAP / DISPLAY button, the LCD will show the current step.
15.03.2010
VDPC174
7
Rev 01
©Velleman nv