Regulatory Information; Regulatory Agency Approvals; Fcc Warning; Ce Conformity For Europe - 3M C2167PW Bedienungsanleitung

13
CHAPTER 4

Regulatory Information

Regulatory Agency Approvals

Your product complies with the following regulatory standards:
 FCC-B
 CE
 CCC
 UL60950/IEC60950/EN60950 certified in compliance with the CB test scheme
This equipment has been tested and found to comply within limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in residential installations. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause interference to radio or television equipment reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

Reorient or relocate the receiving antenna.

Move the equipment away from the receiver.

Consult the dealer or an experienced radio/television technician for additional
suggestions.
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
This device complies with Part 15 of the FCC rules: Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

FCC Warning

To assure continued FCC compliance, the user must use grounded power supply cord and
the provided shielded video interface cable with bonded ferrite cores. If a BNC cable is
going to be used, use only a shielded BNC(5) cable. Also, any unauthorized changes or
modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
3M Touch Systems is not responsible for any radio or television interference caused by
using other than recommended cables and connectors or by unauthorized changes or
modifications to this equipment.

CE Conformity for Europe

The device complies with the requirements of the EU RoHS Directive 2011/65/EU, the
ECC directive 2004/108/EC with regard to "Electromagnetic compatibility" and
2006/95/EC with regard to "Safety".
3M Touch Systems, Inc. Proprietary Information –
3M™ Multi-Touch Display User Guide
TSD-44310 REV C