3M C1500SS Kurzanleitung Seite 4

Connecting the Touch Display
1. Turn off power switch on your computer. You should always turn off the computer before connecting or disconnecting a device.
2. Connect (A) USB or Serial cable to the available port on your computer and plug the other end into the back of display.
3. Connect either the (B) Displayport or (C) HDMI or (D) DVI or (E) VGA cable to the video connector on the display. Connect the other end to
the video card in your computer.
4. Connect the power cord to the (F) power connector on the display. Connect the other end of the power cord to an appropriate grounded power
source.
Mounting the Touch Display
Note: Always use the mounting holes when attaching the brackets or arm mount. Do not drill additional holes in the unit.
VESA Mounting Option
Each display has a VESA mounting pattern on the back to allow for arm mount capability.
Note: To avoid the risk of potential damage to display electronics:
•
Always use the proper VESA sized mounting holes when using an arm attachment. (See table for correct VESA size.) Do not drill additional
holes in the unit to mount plates at other locations.
•
Do not use screws that are longer than specified in the table, they could potentially damage electronics inside the display.
•
If you choose to use a VESA mount or UL listed wall mount bracket, ensure adequate weight load capability.
•
Follow the manufacturer's instructions included with the mounting device to properly attach your display.
VESA mounting
Model dimensions (MM)
M1500SS 75 X 75
C1500SS 75 X 75
M1700SS 100 X 100
M1866PW 100 X 100
M2167PW 100 X 100
C2167PW 100 X 100
C2234SW 100 X 100
M2467PW 100 X 100
100 X 100, 100 X
M2767PW
200
C3266PW 200 X 200
C4267PW 400 X 400
C4667PW 400 X 400
C5567PW 400 X 400
Bracket Mounting Option (Chassis Models Only)
The Chassis Display may come with a hardware accessory kit for mounting the unit into an enclosure. This kit includes screws and mounting
brackets.
Mounting holes are located on 4 sides of the display.
• Always use the supplied screws.
• Brackets can be attached to the edges of the chassis.
USB
Displayport HDMI
Serial
Screw size & Weight Hardware
Max Length Accessory Kit
(MM)
7.4 kg
M4 X 8
(16.3 lbs)
4.2 kg
M4 X 8
(9.2 lbs)
8.6 kg
M4 X 8
(18.9 lbs)
4.9 kg
M4 X 10
(10.8 lbs)
6.4 kg
M4 X 10
(14.1 lbs)
5.7 kg
M4 X 8
(12.6 lbs)
6.4 kg
M4 X 8
(14.0 lbs)
6.6 kg
M4 X 10
(14.6 lbs)
7.7 kg
M4 X 10
(17.0 lbs)
15 kg
M4 X 8
(33 lbs)
23 kg
M6 X 16
(50.7 lbs)
26 kg
M6 X 16
(57.3 lbs)
40 kg
M6 X 16
(88.2 lbs)
3M Touch Systems, Inc. Proprietary Information
VGA
DVI
X
X
X
Power
Connector
2