DETEWE M100-AT4 Installationsanleitung Seite 9

Configuration
After you have restarted the
OpenCom 130, use the Configurator in
the Web console to configure the
M100-AT4 Interface Card. Please also
refer to the OpenCom 130 online help.
Proceed as follows:
1. Log in to the Configurator as a
user with administrator rights.
Note: Firmware version 5.2 or higher
is required in order to configure the
M100-AT4 Interface Card via the
OpenCom 130 Web console. If neces-
sary, load the new firmware via the
SYS Configuration: Firmware menu.
Then load the most recent online help
version via the SYS Configuration:
Components menu. The current
firmware version number of the
OpenCom 130 is displayed in the
System Info: Versions menu.
2. Open the PBX Configuration -
Ports - Slots menu.
Card type a/b Trunk is displayed in
the inserted column for Slot 0/3 if
the card is inserted into the slot.
Note: If the card type is not dis-
played, the interface card has not been
detected. Ensure that the interface card
has been installed correctly and that the
correct firmware version has been
loaded.
The following steps explain how to
configure the M100-AT4 Interface Card.
Installation Guide
3. Click on Slot 0/3 in the table.
The PBX Configuration - Ports -
Slot 0/3 - Change dialogue opens.
4. Select card type a/b Trunk from
the configured list.
5. Confirm with Apply.
After you have configured the M100-
AT4 Interface Card the trunk lines need
to be configured. Start by creating a
new bundle:
6. Open the PBX Configuration:
Trunks: Bundle menu.
The PBX Configuration - Trunks -
Bundle dialogue opens. A list of
the configured bundles is dis-
played.
7. Click on the New button.
The PBX Configuration - Trunks -
Bundle - New dialogue opens.
8. Select Analog trunk from the
Access type list and enter a bundle
name in the Name field.
9. Confirm with Apply.
The newly configured bundle is
displayed in a list in the
PBX Configuration - Trunks -
Bundle dialogue.
M100-AT4 Interface Card
9