Werbung
Verfügbare Sprachen
Verfügbare Sprachen
M100-AT4 Interface Card
The M100-AT4 Interface Card is a
plug-in card which allows the
OpenCom 130 to be connected to
analogue trunk lines. The M100-AT4
Interface Card has four analogue
ports; the supported dialling mode is
dual-tone multifrequency (DTMF).
Installation
The interface card should be installed
on the OpenCom 130 add-on module.
The interface card should be in-
stalled by qualified personnel only!
For information on installing the
OpenCom 130 modules and the inter-
face cards please also refer to the
"OpenCom 130 Mounting and Commis-
sioning" manual.
Proceed as follows:
DANGER! Hazardous voltages
inside the device.
1. Switch off the OpenCom 130. Open
the housing cover.
Installation Guide
Calling Line Identification Presenta-
tion (CLIP) and the transmission of call
charges data (12kHz or 16kHz pulses)
are currently not supported.
Scope of Delivery
One M100-AT4 Interface Card
■
One installation manual
■
2. Remove the interface card from its
transport packaging. Make sure it
is the correct type of card. There is
a sticker with the type name on the
connector.
CAUTION! Static charge can
damage electronic components.
Please observe the regulations re-
garding electrostatically sensitive
components.
M100-AT4 Interface Card
7
Werbung
