DETEWE M100-AT4 Installationsanleitung Seite 10

In order to allow the analogue lines of
the M100-AT4 Interface Card to be
used for outgoing calls, the bundle
needs to be assigned to a route:
10. Open the PBX Configuration:
Trunks: Bundle menu.
The PBX Configuration - Trunks -
Route dialogue opens. Previously
configured routes are displayed in
a list.
11. Click on the New button.
The PBX Configuration - Trunks -
Route - New dialogue opens.
12. Select the bundle you have config-
ured from the Choice list and enter
a route name in the Name field.
Note: In the Choice list, set bundles 2
and 3 to none if you do not want the
OpenCom 130 to search for an alterna-
tive bundle if all trunk lines are busy.
13. Confirm with Apply.
The newly configured route is
displayed in a list in the
PBX Configuration - Trunks -
Route dialogue.
The following steps explain how
to configure each of the M100-AT4
Interface Card ports.
14. Open the PBX Configuration:
Ports: a/b menu.
M100-AT4 Interface Card
10
The PBX Configuration - Ports -
a/b dialogue opens.
Both the basic module's a/b ports
as well as those of the plug-in
cards on the add-on module are
displayed. The four M100-AT4 In-
terface Card ports are displayed
under slot no. 3.
15. Click on the desired a/b port.
The PBX Configuration - Ports -
a/b - Change dialogue opens.
16. Select the configured bundle
from the Bundle list and enter the
desired telephone number in the
Port Ph. No. field.
17. Confirm with Apply.
The newly configured analogue
telephone numbers and the corre-
sponding bundle are displayed in a
list in the PBX Configuration -
Ports - a/b dialogue.
In order to allow incoming calls to be
signalled to the designated terminals,
the telephone numbers configured for
the M100-AT4 Interface Card a/b ports
must be assigned to internal telephone
numbers. Proceed as follows:
18. Open the PBX Configuration: Call
Distribution: Incoming: PTMP
menu.
The PBX Configuration - Call
Distribution - Incoming - PTMP
Installation Guide