General Information; Safety Information; Use Of Hazard Information - Hach 8311 Benutzerhandbuch

Specification
Maximum pressure
Sample connection
Inductive conductivity sensors
Specification
Application
Material
Cell constant K
Accuracy
Measurement range
Conductivity response
Temperature response
Maximum pressure
Maximum temperature

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
Indicates a potentially hazardous situation that may result in minor or moderate injury.
4 English
8315
25 bars
¾ inch NPT ¾ inch NPT
8398 series
Corrosive and fouling applications
2.35 (cm
0—2000 mS/cm
< 1 second
< 2 minutes
N O T I C E
D A N G E R
W A R N I N G
C A U T I O N
8316 8317
25 bars 25 bars
¾ inch NPT
PEEK
-1
)
± 2 %
18 bars
140 °C
8394
25 bars
Tri-Clamp 1½ or
2 inch
8332
Measurement in harsh conditions
PVDF
-1
10 (cm )
± 2 %
100 μS/cm—10 S/cm
< 1 second
< 2 minutes
7.5 bars
120 °C