ViewSonic IFP7560 Bedienungsanleitung Seite 85

Number 8
*3.1.1
Key Pad 8
*3.1.1
Remote 8
Control
Restore 8
default
NOTE:
1. Behavior at lock modes
Lock Mode
Button Lock 1. Lock all buttons on the front panel and RCU, except for
2. All the SET functions should be workable via RS32, even the
MENU Lock 1. Lock "MENU' key of front panel and RCU
2. The Factory and Hospitality modes should not be blocked
POWER Lock 1. Lock "POWER" key on the front and RCU.
2. The SET_POWER on/off should be workable via RS232, but
3. Can not be unlocked by reset in OSD setting
4. Will auto AC power-on in power-lock
5. Under power-lock, the set will not enter power saving when
Remote control Lock the RCU keys, but keep the front panel buttons workable.
disable
s @
s A
s B
s ~
"Power"
ones with according hot key in RCU like Mute,...etc.
for the model using MENU-combined key to enter these two
modes. Alternative approach will be indicated separately if
any limitation by model.
does not mean the POWER lock will be released under this
case.
no PC signal and neither not turn off when no other video
signals after 15min.
76
40 000~009
41 000: UP
001: DOWN
002: LEFT
003: RIGHT
004: ENTER
005: INPUT
006: MENU/(EXIT)
007: EXIT
42 000: Disable
001: Enable
002: Pass through
7E 000
Behavior
Disable: RCU will be no
function
Enabled: RCU controls
normally
Pass through: Display
will bypass the RC code
to connected device via
the RS232 port, but not
react itself.
Recover to factory set-
ting